J.B.D.S. Power

Model SPC-ET(HFP) is a two wire beam smoke detector that consists of an emitter and receiver that cover a distance of 5 – 100 m providing a maximum coverage of 1500 m².

When used on a conventional system the emitter and receiver can be powered directly from the zone or if required the emitter also has an option to be powered from a separate 24 V dc supply. The SPC-ET(HFP) can also be interfaced to Hochiki’s ESP system, the receiver can be connected to a CHQ-SZM/OEM(HFP) Single Zone Module or a CHQ-DZM/OEM(HFP) Dual Zone Module, and the emitter can then be powered directly from the loop/zone or via a separate 24 V dc supply.

The SPC-ET(HFP) comes complete with a termination module which fits directly on to a standard UK dual back box, this allows the detector be surface or flush mounted. Line continuity options can be selected on the termination module and these are based on the Schottky or Zener diode method.

4  5 – 100 m range

4  Automatic contamination compensation

4  Automatic signal strength adjustment

4  Emitter can be powered direct from the zone (or loop)

4  Features a Latching or Non-Latching fault relay

4  Can be interfaced onto ESP (analogue) system via CHQ-SZM/OEM(HFP) or CHQ-DZM/OEM(HFP)

4  Approved by LPCB

Exclusive power supply is required for DC screwdrivers.

 Exclusive power supply converts the electric current from AC outlet (on the primary side) to low-voltage output (HI: DC30V) or (LOW: about DC20V) to supply it to the screwdriver.
 Safe and quiet rotation.
 Please always use HIOS screwdriver in combination with HIOS power supply for safe screw tightening.
 Stable power supply with multiple inputs (AC100V to 240V).
(Not applicable to CLT-100 and MC-70L)

• There is 16 operatrion Modes

• Various Output Options
• Various Function
• NPN Input or PNP Input
• Display Range : 19999 to 99999
• Various Display units
• Power Supply Modes